475 features serial interface connector 9-pin d-sub baud rate up to 921600bps data rate 8 stop rate 1 parity none receiver buffer 1000 data frames power power input input voltage: 10 to 30vdc (terminal block) power consumption 0.9w max. 0.08a @ 10vdc, 0.03a @ 30vdc led power/firmware updating, can tx/rcv, can status for normal and error, uart tx/rcv, terminator status mechanical casing aluminum case dimension 70 mm (w) x 110 mm (d) x 30 mm (h) (2.75" (w) x 4.33" (d) x 1.18" (h)) weight 0.25 kg (0.55 lb) installation din-rail and panel mount environment operating temperature -40 c to +70 c (-40 f to +167 f) storage temperature -40 c to +85 c (-40 f to 185 f) humidity 5% ~ 95% (non-condensing) emission compliance ce class a, fcc class a can interface connector 9-pin male d-sub isolation 3 kvrms dc-dc converter & photocoupler receive buffer 1000 data frames nvram 64kbyte for users define max data flow 10000 fps (can bus) support protocol can 2.0a/2.0b terminator resistor software configurable baud rate 5k,10k, 20k, 40k, 50k, 80k, 100k,125k, 200k, 250k, 400k, 500k, 600k, 800k ,1mbps and user defined ICON-101CS 1-port can to rs-232/422/485 industrial converter (-40 c ~ +70 c) software configurable can and rs-232/422/485 communication parameters fully compliance with can 2.0a and can 2.0b d-sub db9 can port supports 3kv isolation easily setup to can and rs-485 terminator by software configurable powered by 10~30v wide-range dc transmission speed up to 1mbps for can and rs-232 clear led indicators to converter status in progressing provides din-rail mounting -40c ~ +70c wide temperature operating suitable for industrial automation and power automation field applications specifications introduction the can (controller area network) is a serial bus system and is usually used in structuring intelligent industrial device networks and building smart automatic control systems. the ICON-101CS is an industrial converter ideally suitable for can network using traditional rs-232/422/485 devices. it precisely converts messages between can and rs-232/422/485 networks, allowing any pc or devices with rs-232/422/485 interface to communicate with can devices easily. this converter supports can monitor tool and displays the can message received in decimal or hex mode. the ICON-101CS shows the time stamp of each receiving message. the gui management program and programming guide both are ready for use. ext. temp * all specifications and photos are subject to change without notice.
overview embedded systems embedded systems for transportation embedded field controllers industrial firewall digital signage solutions 476 can network can device can device can device ICON-101CS rs-232/422/485 ordering information dimensions ICON-101CS 1-port can to rs-232/422/485 industrial converter axiomtek.com ? 2016 axiomtek co., ltd. all rights reserved. * all specifications and photos are subject to change without notice. embedded microboxes industrial barebone systems industrial chassis backplanes power supplies peripherals & accessories 11
|
